There has now been testimony from a observer of the recount who says :
” I watched the GOP’s Arizona election audit. It was worse than you think. Cyber Ninjas is hunting for bamboo fibers and cheese dust.”
“I expected it to be unconventional. But it was so much worse than that. In more than a decade working on elections, audits and recounts across the country, I’ve never seen one this mismanaged.”
“I was stunned to see spinning conveyor wheels, whizzing hundreds of ballots past “counters,” who struggled to mark, on a tally sheet, each voter’s selection for the presidential and Senate races. They had only a few seconds to record what they saw. Occasionally, I saw a counter look up, realize they missed a ballot and then grab the wheel to stop it. This process sets them up to make so many mistakes, I kept thinking. Humans are terrible at tedious, repetitive tasks; we’re especially bad at counting. That’s why, in all the other audits I’ve seen, bipartisan teams follow a tallying method that allows for careful review and inspection of each ballot, followed by a verification process. I’d never seen an audit use contraptions to speed up the process.
Speed doesn’t necessarily pose a problem if the audit has a process for catching and correcting mistakes. But it didn’t. Each table had three volunteers tallying the ballots, and their tally sheets were considered “done” as long as two of the three tallies matched, and the third was off by no more than two ballots. The volunteers only recounted if their tally sheets had three or more errors — a threshold they stuck to, no matter how many ballots a stack contained, whether it was 50 or 100. This allowed for a shocking amount of error. Some table managers told the counters to go back and recount when there were too many errors; other table managers just instructed the counters to fix their “math mistakes.” At no point did anyone track how many ballots they were processing at their station, to ensure that none got added or lost during handling.”