Home › Forums › Around the House › Ideas (and plans) on building a tabletop shtender
- This topic has 2 replies, 3 voices, and was last updated 13 years, 11 months ago by I can only try.
-
AuthorPosts
-
May 18, 2010 2:28 pm at 2:28 pm #591680afarkovitsParticipant
I am thinking about building a tabletop shtender. I know what i would like but dont have a clue what to do.
I would like it to be approx. 18″ x 18″ base. I would also like the front top to have a lip for seforim when I sit (without opening door). I am about 6′ tall so it would need to be sufficiently high.
Any ideas on where to get detailed plans to build myself (or to buy)?
May 18, 2010 2:58 pm at 2:58 pm #685067Dr. PepperParticipantIf it is more than 12 inches deep or so you’ll need plywood or pressed wood. I think 12 inches deep is adequate. You can still have it 18 inches long if you wish.
I got an expensive piece of either pine wood or oak and made sure there were no knots in it. Go to your local Home Depot, look at the different pieces of wood available, go home and design it. Home Depot will make straight cuts in the wood but no angle cuts so you’ll need your own saw.
Before I put in the screws I drilled a pilot hole (about .25 inches wide and .25 inches deep) and after putting in the screw I filled the cavity with wood paste (or whatever it’s called).
You can then sand down the entire surface so it is smooth before staining the wood and glossing it. I recommend using 2 or three layers of gloss.
Interestingly, I was 14 or 15 at the time and couldn’t wait to get to the Bais Medrash in the morning so I could use the shtender.
Good luck.
May 21, 2010 5:16 pm at 5:16 pm #685068I can only tryMemberThis thread may have some useful info re: shtender design and construction:
-
AuthorPosts
- You must be logged in to reply to this topic.